U3895 Rover 10 Diagnostic Trouble Code

U3895 Rover 10 code definition:
U3895 is a kind of OBD-II Diagnostic U-Network Diagnostic Trouble Code for Rover 10.

U3895 Rover 10 is defined as Camshaft Position Sensor A Circuit Low. This means the CMP (camshaft position) sensor circuit on engine bank 1 sends an irregular reading. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a U3895 Rover 10 diagnostic trouble code may include:

Faulty O2 Sensor
Lack of power
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
Diminished fuel efficiency

Possible Causes :

A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
Faulty IMRC actuator relay (if equipped)
Fuel with a large percentage of sulfur will clog the DPF quickly

Common Misdiagnoses

Exhaust Gas Recirculation System Valve 1 Problem
BBV Sensor Circuit Low Voltage Problem
Transmission Engaged At High Throttle Angle Problem
Cruise Inhibit Control Circuit Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem

Repair Processes :

Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors. Pull the connectors apart and carefully look at the terminals (the metal parts) inside the connectors. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground.

Process Tips

Diagnostic trouble code U3895 Rover 10 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before U3895 Rover 10.

Fortunately, U3895 Rover 10 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.