U3894 Mclaren F1 Diagnostic Trouble Code

U3894 Mclaren F1 code definition:
U3894 is a kind of OBD-II Diagnostic U-Network Diagnostic Trouble Code for Mclaren F1.

U3894 Mclaren F1 is defined as Camshaft Position Sensor A Circuit Low. This means the CMP (camshaft position) sensor circuit on engine bank 1 sends an irregular reading. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a U3894 Mclaren F1 diagnostic trouble code may include:

Poor fuel economy
Possible spark knock (detonation / pre-ignition)
Misfire
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected

Possible Causes :

Fuel with a large percentage of sulfur will clog the DPF quickly
The Mass Airflow sensor will also cause this problem. Mass Airflow circuit malfunction.
A large vacuum leak would cause a massive amount of un-metered air to enter the intake manifold resulting in an overly lean mixture.

Common Misdiagnoses

Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
Kick-Down Switch Failed Short Problem
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit Problem

Repair Processes :

Find out what kind of system you have and verify that voltage to the fuel level sensor is present at the fuel pump wiring harness. Look at the plug wires to make sure they are not burnt or laying on the exhaust. If you find a related TSB, the information will often help in diagnosing the code in question as TSBs are crested from many thousands of repairs.

Process Tips

Diagnostic trouble code U3894 Mclaren F1 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before U3894 Mclaren F1.

Fortunately, U3894 Mclaren F1 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.