U3672 Subaru Pleo Diagnostic Trouble Code

U3672 Subaru Pleo code definition:
U3672 is a kind of OBD-II Diagnostic U-Network Diagnostic Trouble Code for Subaru Pleo.

U3672 Subaru Pleo is triggered when the bank 1 camshaft position sensor doesn't match the signal from the crankshaft position sensor. The spark should have a light tan color. If the sensor probe comes with white and chalky parts, this means it has been lagging between switching phases, and should be replaced.

Symptoms

Symptoms of a U3672 Subaru Pleo diagnostic trouble code may include:
  • Fuel pressure too high
  • Diminished fuel efficiency
  • Rich or lean exhaust
  • Hesitation upon acceleration
Place of U3672 in engine

Possible Causes :

  • A plugged converter will cause of host of driveability problems as well as set this code. A severely plugged converter will result in the inability to increase rpm when under load. Look for a code such as P0421 -- catalytic converter efficiency below threshold if the converter indicating a faulty converter.
  • Dirty air cleaner element Damaged DPF
  • Faulty IMRC actuator relay (if equipped)

Common Misdiagnoses

  1. Control Module Throttle Actuator Position Performance Problem
  2. Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
  3. Cruise Vehicle Speed/Set Speed Difference Too High Problem
  4. Kick-Down Switch Failed Short Problem
  5. Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit Problem

Repair Processes :

You might continue by connecting the scanner to the vehicle diagnostic connector and retrieving all stored codes and freeze frame data. Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed. Look for damage to the tank indicating impact that may have damaged the fuel pump or sender.

Process Tips

Diagnostic trouble code U3672 Subaru Pleo is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before U3672 Subaru Pleo.

Fortunately, U3672 Subaru Pleo is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

Copyright 2021 - https://diagnosticTrouble.com

Small Logo