U3122 Abarth Mono Diagnostic Trouble Code

U3122 Abarth Mono code definition:
U3122 is a kind of OBD-II Diagnostic U-Network Diagnostic Trouble Code for Abarth Mono.

U3122 Abarth Mono is triggered when the bank 1 camshaft position sensor doesn't match the signal from the crankshaft position sensor. This is because the barometric pressure sensor is part of the MAF sensor. Sometimes, the MAF's sensing wire can accumulate and get covered with dirt, dust and/or oil residue, which can also lead to the error code.

Symptoms

Symptoms of a U3122 Abarth Mono diagnostic trouble code may include:

Poor acceleration
Cherry red hot catalytic converter
Possible spark knock (detonation / pre-ignition)
Rich or lean exhaust

Possible Causes :

Faulty IMRC actuator relay (if equipped)
A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
A plugged converter will cause of host of driveability problems as well as set this code. A severely plugged converter will result in the inability to increase rpm when under load. Look for a code such as P0421 -- catalytic converter efficiency below threshold if the converter indicating a faulty converter.

Common Misdiagnoses

Vehicle Speed Output Circuit Problem
Cruise Control Servo Indicates Low Problem
A/C System High Pressure High Temperature Problem
PCM Stack Overrun Problem
Transmission Control Module Reprogrammable Memory Problem

Repair Processes :

It should be pretty close to battery voltage (12 volts). If not, then this is the circuit that has the problem. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed.

Process Tips

Diagnostic trouble code U3122 Abarth Mono is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before U3122 Abarth Mono.

Fortunately, U3122 Abarth Mono is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.