U3111 Jeep Icon Diagnostic Trouble Code

U3111 Jeep Icon code definition:
U3111 is a kind of OBD-II Diagnostic U-Network Diagnostic Trouble Code for Jeep Icon.

U3111 Jeep Icon is defined as Cylinder 3 Injector Circuit Malfunction. This code means the PCM (powertrain control module, also known as ECM or engine control) has detected a problem in the injector or its wiring, or in injector circuit for cylinder 3. If the car doesn't start, they will proceed by testing the voltage at the fuel pump connector and see if the fuel pump relay, fuse, and PCM circuitry should be inspected.

Symptoms

Symptoms of a U3111 Jeep Icon diagnostic trouble code may include:

Hesitation upon acceleration
Excessive exhaust leak
Rich or lean exhaust
Lack of power

Possible Causes :

Some aftermarket accessories and performance modifications
A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
Faulty IMRC actuator relay (if equipped)

Common Misdiagnoses

Crankshaft Position Sensor Circuit Performance Problem
TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
Kick-Down Switch Failed Short Problem

Repair Processes :

Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. If the scan tool has that capability, and the scan tool can operate the IMRC valves, then the problem is either resolved and a simple code clearing is all that's left or a new PCM would be called for.

Process Tips

Diagnostic trouble code U3111 Jeep Icon is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before U3111 Jeep Icon.

Fortunately, U3111 Jeep Icon is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.