U2988 Toyota Runx Diagnostic Trouble Code

U2988 Toyota Runx code definition:
U2988 is a kind of OBD-II Diagnostic U-Network Diagnostic Trouble Code for Toyota Runx.

U2988 Toyota Runx is triggered when the bank 1 camshaft position sensor doesn't match the signal from the crankshaft position sensor. Other serious codes may cause this code to pop up, and they may come with dangerous drivability issues that may expose you to safety risks and cause damage to the engine in the long run.

Symptoms

Symptoms of a U2988 Toyota Runx diagnostic trouble code may include:

If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
Corroded or damaged connector
Reduction in engine performance, especially at low RPM levels
Rich or lean exhaust

Possible Causes :

The Mass Airflow sensor will also cause this problem. Mass Airflow circuit malfunction.
Fuel with a large percentage of sulfur will clog the DPF quickly
Some aftermarket accessories and performance modifications

Common Misdiagnoses

Exhaust Gas Recirculation System Valve 1 Problem
BBV Sensor Circuit Low Voltage Problem
Transmission Engaged At High Throttle Angle Problem
Cruise Inhibit Control Circuit Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem

Repair Processes :

Find out what kind of system you have and verify that voltage to the fuel level sensor is present at the fuel pump wiring harness. Look at the plug wires to make sure they are not burnt or laying on the exhaust. It should be pretty close to battery voltage (12 volts). If not, then this is the circuit that has the problem.

Process Tips

Diagnostic trouble code U2988 Toyota Runx is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before U2988 Toyota Runx.

Fortunately, U2988 Toyota Runx is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.