U2628 Saturn Sl1 Diagnostic Trouble Code

U2628 Saturn Sl1 code definition:
U2628 is a kind of OBD-II Diagnostic U-Network Diagnostic Trouble Code for Saturn Sl1.

U2628 Saturn Sl1 is described as Fuel System Too Rich, which basically means bank 1's oxygen sensor has detected a rich condition of fuel. This means there's not enough oxygen in the exhaust from too much fuel being delivered into the air and gas mixture for combusion. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a U2628 Saturn Sl1 diagnostic trouble code may include:

Rich or lean exhaust
Fuel pressure too low
Engine surge
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.

Possible Causes :

An air leak forward of the DPF will change the sensor readings resulting in the code
Rusty exhaust systems, cracked exhaust manifolds or damaged or missing gaskets or donuts will cause air leaks.
Faulty IMRC actuator relay (if equipped)

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

It should be pretty close to battery voltage (12 volts). If not, then this is the circuit that has the problem. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Look at the plug wires to make sure they are not burnt or laying on the exhaust.

Process Tips

Diagnostic trouble code U2628 Saturn Sl1 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before U2628 Saturn Sl1.

Fortunately, U2628 Saturn Sl1 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.