U2574 Sunbeam Alpine Diagnostic Trouble Code

U2574 Sunbeam Alpine code definition:
U2574 is a kind of OBD-II Diagnostic U-Network Diagnostic Trouble Code for Sunbeam Alpine.

U2574 Sunbeam Alpine is triggered when the bank 1 camshaft position sensor doesn't match the signal from the crankshaft position sensor. Other serious codes may cause this code to pop up, and they may come with dangerous drivability issues that may expose you to safety risks and cause damage to the engine in the long run.

Symptoms

Symptoms of a U2574 Sunbeam Alpine diagnostic trouble code may include:

The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
Faulty PCM
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
Hesitation upon acceleration

Possible Causes :

A plugged converter will cause of host of driveability problems as well as set this code. A severely plugged converter will result in the inability to increase rpm when under load. Look for a code such as P0421 -- catalytic converter efficiency below threshold if the converter indicating a faulty converter.
Dirty air cleaner element Damaged DPF
An air leak forward of the DPF will change the sensor readings resulting in the code

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

You might continue by connecting the scanner to the vehicle diagnostic connector and retrieving all stored codes and freeze frame data. Look at the plug wires to make sure they are not burnt or laying on the exhaust. Look for damage to the tank indicating impact that may have damaged the fuel pump or sender.

Process Tips

Diagnostic trouble code U2574 Sunbeam Alpine is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before U2574 Sunbeam Alpine.

Fortunately, U2574 Sunbeam Alpine is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.