U251C Talbot Alpine Diagnostic Trouble Code

U251C Talbot Alpine code definition:
U251C is a kind of OBD-II Diagnostic U-Network Diagnostic Trouble Code for Talbot Alpine.

U251C Talbot Alpine is triggered when the bank 1 camshaft position sensor doesn't match the signal from the crankshaft position sensor. If the car doesn't start, they will proceed by testing the voltage at the fuel pump connector and see if the fuel pump relay, fuse, and PCM circuitry should be inspected.

Symptoms

Symptoms of a U251C Talbot Alpine diagnostic trouble code may include:

Blown fuse (if applicable)
Engine surge
Reduction in engine performance, especially at low RPM levels
Rich or lean exhaust

Possible Causes :

Faulty IMRC actuator relay (if equipped)
A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
Dirty air cleaner element Damaged DPF

Common Misdiagnoses

Crankshaft Position Sensor Circuit Performance Problem
TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
Kick-Down Switch Failed Short Problem

Repair Processes :

Check to make sure they are not burnt or corroded. If in doubt, get some Electrical Contact cleaner at any parts store if cleaning of the terminals is needed. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. If the engine displays a miss and there wasn't a code, determine which cylinder is misfiring. If the exhaust manifold is visible, spay or pour a small amount of water on each cylinder exhaust port. Water will evaporate immediately on good cylinders and slowly on the missing cylinder. If this can't be accomplished pull the plugs and check the condition.

Process Tips

Diagnostic trouble code U251C Talbot Alpine is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before U251C Talbot Alpine.

Fortunately, U251C Talbot Alpine is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.