U247F Bmw 330 Diagnostic Trouble Code

U247F Bmw 330 code definition:
U247F is a kind of OBD-II Diagnostic U-Network Diagnostic Trouble Code for Bmw 330.

U247F Bmw 330 is defined as Knock Sensor Circuit Range Performance (Bank 1 or Single Sensor). This refers to camshaft timing, which in this case is over-retarded. If the car doesn't start, they will proceed by testing the voltage at the fuel pump connector and see if the fuel pump relay, fuse, and PCM circuitry should be inspected.

Symptoms

Symptoms of a U247F Bmw 330 diagnostic trouble code may include:
Place of U247F in engine

Possible Causes :

  • A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
  • Faulty IMRC actuator relay (if equipped)
  • Dirty air cleaner element Damaged DPF

Common Misdiagnoses

  1. TP Sensor Learn Not Complete Problem
  2. Low Coolant Circuit Problem
  3. Cruise Control System - Vehicle Accel Too High Problem
  4. TFP Valve Position Switch-Drive Without Drive Ratio Problem
  5. Problem

Repair Processes :

Once located, visually inspect the connectors and wiring. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed.

Process Tips

Diagnostic trouble code U247F Bmw 330 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before U247F Bmw 330.

Fortunately, U247F Bmw 330 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

About Us | Contact | Privacy

Copyright 2023 - https://DiagnosticTrouble.com

Small Logo