U2417 Vauxhall Wyvern Diagnostic Trouble Code

U2417 Vauxhall Wyvern code definition:
U2417 is a kind of OBD-II Diagnostic U-Network Diagnostic Trouble Code for Vauxhall Wyvern.

U2417 Vauxhall Wyvern shows up when there's an electrical problem that causes the fuel volume regulator to malfunction and open. It's quite an unusual problem and likely intermittent. If the car doesn't start, they will proceed by testing the voltage at the fuel pump connector and see if the fuel pump relay, fuse, and PCM circuitry should be inspected.

Symptoms

Symptoms of a U2417 Vauxhall Wyvern diagnostic trouble code may include:

The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
Faulty PCM
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
Diminished fuel efficiency

Possible Causes :

The Mass Airflow sensor is a hot wire that senses the volume of air entering the intake manifold. The computer uses this information to control fuel mixture.
Defective ECU strategies or components will prevent proper regeneration
An air leak forward of the DPF will change the sensor readings resulting in the code

Common Misdiagnoses

Vehicle Speed Output Circuit Problem
Cruise Control Servo Indicates Low Problem
A/C System High Pressure High Temperature Problem
PCM Stack Overrun Problem
Transmission Control Module Reprogrammable Memory Problem

Repair Processes :

Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Once located, visually inspect the connectors and wiring. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors.

Process Tips

Diagnostic trouble code U2417 Vauxhall Wyvern is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before U2417 Vauxhall Wyvern.

Fortunately, U2417 Vauxhall Wyvern is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.