U20EE Holden Te Diagnostic Trouble Code

U20EE Holden Te code definition:
U20EE is a kind of OBD-II Diagnostic U-Network Diagnostic Trouble Code for Holden Te.

U20EE Holden Te is defined as Knock Sensor Circuit Range Performance (Bank 1 or Single Sensor). This refers to camshaft timing, which in this case is over-retarded. Other serious codes may cause this code to pop up, and they may come with dangerous drivability issues that may expose you to safety risks and cause damage to the engine in the long run.

Symptoms

Symptoms of a U20EE Holden Te diagnostic trouble code may include:

Rich or lean exhaust
Fuel pressure too low
Engine surge
Poor acceleration

Possible Causes :

Faulty IMRC actuator relay (if equipped)
A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)

Common Misdiagnoses

Exhaust Gas Recirculation System Valve 1 Problem
BBV Sensor Circuit Low Voltage Problem
Transmission Engaged At High Throttle Angle Problem
Cruise Inhibit Control Circuit Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem

Repair Processes :

If the scan tool has that capability, and the scan tool can operate the IMRC valves, then the problem is either resolved and a simple code clearing is all that's left or a new PCM would be called for. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector.

Process Tips

Diagnostic trouble code U20EE Holden Te is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before U20EE Holden Te.

Fortunately, U20EE Holden Te is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.