U2020 Toyota Crown Diagnostic Trouble Code

U2020 Toyota Crown code definition:
U2020 is a kind of OBD-II Diagnostic U-Network Diagnostic Trouble Code for Toyota Crown.

U2020 Toyota Crown is defined as Knock Sensor Circuit Range Performance (Bank 1 or Single Sensor). This refers to camshaft timing, which in this case is over-retarded. Other symptoms that may indicate this problem are when the Check Engine Light illuminates and when there is a visible lack of engine power.

Symptoms

Symptoms of a U2020 Toyota Crown diagnostic trouble code may include:

Hesitation upon acceleration
Excessive exhaust leak
Rich or lean exhaust
Lack of power

Possible Causes :

Faulty IMRC actuator relay (if equipped)
A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
Some aftermarket accessories and performance modifications

Common Misdiagnoses

Vehicle Speed Output Circuit Problem
Cruise Control Servo Indicates Low Problem
A/C System High Pressure High Temperature Problem
PCM Stack Overrun Problem
Transmission Control Module Reprogrammable Memory Problem

Repair Processes :

Pack the connector cavity with dielectric silicone compound (same stuff they use for light bulb sockets and spark plug wires) and reassemble. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground.

Process Tips

Diagnostic trouble code U2020 Toyota Crown is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before U2020 Toyota Crown.

Fortunately, U2020 Toyota Crown is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.