U0337 Italdesign Legram is a DTC or a diagnostic trouble code. It is a check engine light code which indicates that the catalyst's system efficiency is less than the required threshold. In simple terms, it means that more pollution is added into the air than what was supposed to be because of your car. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.
SymptomsSymptoms of a U0337 Italdesign Legram diagnostic trouble code may include:
Possible Causes :
Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Check to make sure they are not burnt or corroded. If in doubt, get some Electrical Contact cleaner at any parts store if cleaning of the terminals is needed.
Diagnostic trouble code U0337 Italdesign Legram is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.
Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before U0337 Italdesign Legram.
Fortunately, U0337 Italdesign Legram is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.