U0195 Smart Brabus Diagnostic Trouble Code

U0195 Smart Brabus code definition:
U0195 is a kind of OBD-II Diagnostic U-Network Diagnostic Trouble Code for Smart Brabus.

U0195 Smart Brabus is defined as Knock Sensor Circuit Range Performance (Bank 1 or Single Sensor). This refers to camshaft timing, which in this case is over-retarded. The spark should have a light tan color. If the sensor probe comes with white and chalky parts, this means it has been lagging between switching phases, and should be replaced.

Symptoms

Symptoms of a U0195 Smart Brabus diagnostic trouble code may include:
  • Faulty O2 Sensor
  • Lack of power
  • If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
  • The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
Place of U0195 in engine

Possible Causes :

  • An air leak forward of the DPF will change the sensor readings resulting in the code
  • Rusty exhaust systems, cracked exhaust manifolds or damaged or missing gaskets or donuts will cause air leaks.
  • Fuel with a large percentage of sulfur will clog the DPF quickly

Common Misdiagnoses

  1. Exhaust Gas Recirculation System Valve 1 Problem
  2. BBV Sensor Circuit Low Voltage Problem
  3. Transmission Engaged At High Throttle Angle Problem
  4. Cruise Inhibit Control Circuit Problem
  5. TFP Valve Position Switch-Drive Without Drive Ratio Problem

Repair Processes :

It should be pretty close to battery voltage (12 volts). If not, then this is the circuit that has the problem. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Look at the plug wires to make sure they are not burnt or laying on the exhaust.

Process Tips

Diagnostic trouble code U0195 Smart Brabus is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before U0195 Smart Brabus.

Fortunately, U0195 Smart Brabus is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

About Us | Contact | Privacy

Copyright 2022 - https://DiagnosticTrouble.com

Small Logo