U0149 Peugeot 3008 Diagnostic Trouble Code

U0149 Peugeot 3008 code definition:
U0149 is a kind of OBD-II Diagnostic U-Network Diagnostic Trouble Code for Peugeot 3008.

U0149 Peugeot 3008 is defined as Camshaft Position Sensor A Circuit Low. This means the CMP (camshaft position) sensor circuit on engine bank 1 sends an irregular reading. This is because the barometric pressure sensor is part of the MAF sensor. Sometimes, the MAF's sensing wire can accumulate and get covered with dirt, dust and/or oil residue, which can also lead to the error code.

Symptoms

Symptoms of a U0149 Peugeot 3008 diagnostic trouble code may include:
  • Engine surge
  • Blown fuse (if applicable)
  • Lack of power
  • Hesitation upon acceleration
Place of U0149 in engine

Possible Causes :

  • Some aftermarket accessories and performance modifications
  • A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
  • Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)

Common Misdiagnoses

  1. Vehicle Speed Output Circuit Problem
  2. Cruise Control Servo Indicates Low Problem
  3. A/C System High Pressure High Temperature Problem
  4. PCM Stack Overrun Problem
  5. Transmission Control Module Reprogrammable Memory Problem

Repair Processes :

Look at the plug wires to make sure they are not burnt or laying on the exhaust. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Once located, visually inspect the connectors and wiring. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors.

Process Tips

Diagnostic trouble code U0149 Peugeot 3008 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before U0149 Peugeot 3008.

Fortunately, U0149 Peugeot 3008 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

Copyright 2021 - https://diagnosticTrouble.com

Small Logo