P307E Nissan Tino Diagnostic Trouble Code

P307E Nissan Tino code definition:
P307E is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Nissan Tino.

P307E Nissan Tino is defined as Ignition Coil B Primary/Secondary Circuit Malfunction.This code is a generic trouble code, meaning it applies to all vehicles equipped with OBD-II tool, or vehicles made since 1996 up to present. The PCM then uses this data to provide the right strategies for the fuel delivery and ignition timing of the engine.

Symptoms

Symptoms of a P307E Nissan Tino diagnostic trouble code may include:

Vacuum leak on the engine
Reduction in engine performance, especially at low RPM levels
Engine surge
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected

Possible Causes :

Fuel with a large percentage of sulfur will clog the DPF quickly
The Mass Airflow sensor will also cause this problem. Mass Airflow circuit malfunction.
Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)

Common Misdiagnoses

Vehicle Speed Output Circuit Problem
Cruise Control Servo Indicates Low Problem
A/C System High Pressure High Temperature Problem
PCM Stack Overrun Problem
Transmission Control Module Reprogrammable Memory Problem

Repair Processes :

Find out what kind of system you have and verify that voltage to the fuel level sensor is present at the fuel pump wiring harness. Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed. It should be pretty close to battery voltage (12 volts). If not, then this is the circuit that has the problem.

Process Tips

Diagnostic trouble code P307E Nissan Tino is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P307E Nissan Tino.

Fortunately, P307E Nissan Tino is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.