P307E Nissan Juke Diagnostic Trouble Code

P307E Nissan Juke code definition:
P307E is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Nissan Juke.

P307E Nissan Juke is defined as Cylinder 3 Injector Circuit Malfunction. This code means the PCM (powertrain control module, also known as ECM or engine control) has detected a problem in the injector or its wiring, or in injector circuit for cylinder 3. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a P307E Nissan Juke diagnostic trouble code may include:

Vacuum leak on the engine
Reduction in engine performance, especially at low RPM levels
Engine surge
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected

Possible Causes :

Fuel with a large percentage of sulfur will clog the DPF quickly
The Mass Airflow sensor will also cause this problem. Mass Airflow circuit malfunction.
Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

Find out what kind of system you have and verify that voltage to the fuel level sensor is present at the fuel pump wiring harness. Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed. It should be pretty close to battery voltage (12 volts). If not, then this is the circuit that has the problem.

Process Tips

Diagnostic trouble code P307E Nissan Juke is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P307E Nissan Juke.

Fortunately, P307E Nissan Juke is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.