P3056 Subaru Outback 3 Diagnostic Trouble Code

P3056 Subaru Outback 3 code definition:
P3056 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Subaru Outback 3.

P3056 Subaru Outback 3 shows up when there's an electrical problem that causes the fuel volume regulator to malfunction and open. It's quite an unusual problem and likely intermittent. This is because the barometric pressure sensor is part of the MAF sensor. Sometimes, the MAF's sensing wire can accumulate and get covered with dirt, dust and/or oil residue, which can also lead to the error code.

Symptoms

Symptoms of a P3056 Subaru Outback 3 diagnostic trouble code may include:

Fuel pressure too high
Diminished fuel efficiency
Rich or lean exhaust
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.

Possible Causes :

Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.
Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.
Faulty IMRC actuator relay (if equipped)

Common Misdiagnoses

Vehicle Speed Output Circuit Problem
Cruise Control Servo Indicates Low Problem
A/C System High Pressure High Temperature Problem
PCM Stack Overrun Problem
Transmission Control Module Reprogrammable Memory Problem

Repair Processes :

Look for damage to the tank indicating impact that may have damaged the fuel pump or sender. Pack the connector cavity with dielectric silicone compound (same stuff they use for light bulb sockets and spark plug wires) and reassemble.

Process Tips

Diagnostic trouble code P3056 Subaru Outback 3 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P3056 Subaru Outback 3.

Fortunately, P3056 Subaru Outback 3 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.