P303E Volvo 123 Diagnostic Trouble Code

P303E Volvo 123 code definition:
P303E is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Volvo 123.

P303E Volvo 123 is defined as Camshaft Position Sensor A Circuit Low. This means the CMP (camshaft position) sensor circuit on engine bank 1 sends an irregular reading. Other serious codes may cause this code to pop up, and they may come with dangerous drivability issues that may expose you to safety risks and cause damage to the engine in the long run.

Symptoms

Symptoms of a P303E Volvo 123 diagnostic trouble code may include:

The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
Faulty PCM
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
Diminished fuel efficiency

Possible Causes :

Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.
Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.
An air leak forward of the DPF will change the sensor readings resulting in the code

Common Misdiagnoses

Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
Kick-Down Switch Failed Short Problem
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit Problem

Repair Processes :

Find out what kind of system you have and verify that voltage to the fuel level sensor is present at the fuel pump wiring harness. Look at the plug wires to make sure they are not burnt or laying on the exhaust. Now, clear the codes and test-drive the vehicle to see if the code is reset.

Process Tips

Diagnostic trouble code P303E Volvo 123 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P303E Volvo 123.

Fortunately, P303E Volvo 123 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.