P300D Bmw 640 Diagnostic Trouble Code

P300D Bmw 640 code definition:
P300D is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Bmw 640.

P300D Bmw 640 is defined as Knock Sensor Circuit Range Performance (Bank 1 or Single Sensor). This refers to camshaft timing, which in this case is over-retarded. The spark should have a light tan color. If the sensor probe comes with white and chalky parts, this means it has been lagging between switching phases, and should be replaced.

Symptoms

Symptoms of a P300D Bmw 640 diagnostic trouble code may include:

Rich or lean exhaust
Fuel pressure too low
Engine surge
Poor acceleration

Possible Causes :

Faulty IMRC actuator relay (if equipped)
A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors. Pull the connectors apart and carefully look at the terminals (the metal parts) inside the connectors. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Look at the plug wires to make sure they are not burnt or laying on the exhaust.

Process Tips

Diagnostic trouble code P300D Bmw 640 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P300D Bmw 640.

Fortunately, P300D Bmw 640 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.