P296B Ford Fusion Diagnostic Trouble Code

P296B Ford Fusion code definition:
P296B is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Ford Fusion.

P296B Ford Fusion is described as Oxygen Sensor Circuit No Activity Detected (Bank 1, Sensor 1). This means there's a problem in the front oxygen sensor on Bank 1, as the O2 sensor is inactive. The PCM then uses this data to provide the right strategies for the fuel delivery and ignition timing of the engine.

Symptoms

Symptoms of a P296B Ford Fusion diagnostic trouble code may include:

Possible spark knock (detonation / pre-ignition)
Poor fuel economy
The engine oil will exhibit dilution from the ECUs attempts to increase engine temperature. Some vehicles advance the fuel injection timing slightly after top center to afterburn a small amount of fuel to increase exhaust temperatures. Some of this fuel enters the crankcase. When the ECU determines the necessity to regenerate the DPF, the service life of the oil be shortened significantly
Engine surge

Possible Causes :

Rusty exhaust systems, cracked exhaust manifolds or damaged or missing gaskets or donuts will cause air leaks.
An air leak forward of the DPF will change the sensor readings resulting in the code
Defective ECU strategies or components will prevent proper regeneration

Common Misdiagnoses

Crankshaft Position Sensor Circuit Performance Problem
TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
Kick-Down Switch Failed Short Problem

Repair Processes :

Oxygen sensors signal the engine management computer the amount of oxygen present in the exhaust, which is used in determining and controlling the fuel ratio. You might continue by connecting the scanner to the vehicle diagnostic connector and retrieving all stored codes and freeze frame data. Find out what kind of system you have and verify that voltage to the fuel level sensor is present at the fuel pump wiring harness.

Process Tips

Diagnostic trouble code P296B Ford Fusion is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P296B Ford Fusion.

Fortunately, P296B Ford Fusion is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.