P2948 Sunbeam-talbot Mk Iii Diagnostic Trouble Code

P2948 Sunbeam-talbot Mk Iii code definition:
P2948 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Sunbeam-talbot Mk Iii.

P2948 Sunbeam-talbot Mk Iii or the Evaporative Emission Control System Incorrect Purge Flow is the set whenever the computer sees that there is a problem with the flow coming from the purge valve or the purge flow is not enough within the EVAP system. If the car doesn't start, they will proceed by testing the voltage at the fuel pump connector and see if the fuel pump relay, fuse, and PCM circuitry should be inspected.

Symptoms

Symptoms of a P2948 Sunbeam-talbot Mk Iii diagnostic trouble code may include:

Faulty O2 Sensor
Lack of power
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
Engine surge

Possible Causes :

Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)
Rough running engine due to misfiring plugs. Many engines have misfire codes to indicate the cylinder effected, such as P0307 for number 7.
Fuel with a large percentage of sulfur will clog the DPF quickly

Common Misdiagnoses

TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem
Problem

Repair Processes :

With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. If you find a related TSB, the information will often help in diagnosing the code in question as TSBs are crested from many thousands of repairs. Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed.

Process Tips

Diagnostic trouble code P2948 Sunbeam-talbot Mk Iii is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P2948 Sunbeam-talbot Mk Iii.

Fortunately, P2948 Sunbeam-talbot Mk Iii is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.