P288C Audi S6 Diagnostic Trouble Code

P288C Audi S6 code definition:
P288C is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Audi S6.

P288C Audi S6 is described as Fuel Rail Pressure Sensor Circuit Malfunction. This code is strictly about the incoming signal from the FRP (fuel rail pressure) sensor falling below the calibrated limit for a certain period of time. The spark should have a light tan color. If the sensor probe comes with white and chalky parts, this means it has been lagging between switching phases, and should be replaced.

Symptoms

Symptoms of a P288C Audi S6 diagnostic trouble code may include:

Faulty or damaged wiring
The engine oil will exhibit dilution from the ECUs attempts to increase engine temperature. Some vehicles advance the fuel injection timing slightly after top center to afterburn a small amount of fuel to increase exhaust temperatures. Some of this fuel enters the crankcase. When the ECU determines the necessity to regenerate the DPF, the service life of the oil be shortened significantly
Poor fuel economy
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.

Possible Causes :

An air leak forward of the DPF will change the sensor readings resulting in the code
Rusty exhaust systems, cracked exhaust manifolds or damaged or missing gaskets or donuts will cause air leaks.
A large vacuum leak would cause a massive amount of un-metered air to enter the intake manifold resulting in an overly lean mixture.

Common Misdiagnoses

Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
Kick-Down Switch Failed Short Problem
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit Problem

Repair Processes :

Once located, visually inspect the connectors and wiring. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Oxygen sensors signal the engine management computer the amount of oxygen present in the exhaust, which is used in determining and controlling the fuel ratio.

Process Tips

Diagnostic trouble code P288C Audi S6 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P288C Audi S6.

Fortunately, P288C Audi S6 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.