P286C Datsun Pulsar Diagnostic Trouble Code

P286C Datsun Pulsar code definition:
P286C is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Datsun Pulsar.

P286C Datsun Pulsar is described as Oxygen Sensor Circuit No Activity Detected (Bank 1, Sensor 1). This means there's a problem in the front oxygen sensor on Bank 1, as the O2 sensor is inactive. This is because the barometric pressure sensor is part of the MAF sensor. Sometimes, the MAF's sensing wire can accumulate and get covered with dirt, dust and/or oil residue, which can also lead to the error code.

Symptoms

Symptoms of a P286C Datsun Pulsar diagnostic trouble code may include:

Engine surge
Blown fuse (if applicable)
Lack of power
Diminished fuel efficiency

Possible Causes :

The Mass Airflow sensor is a hot wire that senses the volume of air entering the intake manifold. The computer uses this information to control fuel mixture.
Defective ECU strategies or components will prevent proper regeneration
Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)

Common Misdiagnoses

TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem
Problem

Repair Processes :

With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. It should be pretty close to battery voltage (12 volts). If not, then this is the circuit that has the problem.

Process Tips

Diagnostic trouble code P286C Datsun Pulsar is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P286C Datsun Pulsar.

Fortunately, P286C Datsun Pulsar is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.