P2813 Morris Cowley Diagnostic Trouble Code

P2813 Morris Cowley code definition:
P2813 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Morris Cowley.

P2813 Morris Cowley is described as Fuel Rail Pressure Sensor Circuit Malfunction. This code is strictly about the incoming signal from the FRP (fuel rail pressure) sensor falling below the calibrated limit for a certain period of time. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a P2813 Morris Cowley diagnostic trouble code may include:

Misfire
Misfire
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
Engine surge

Possible Causes :

Rusty exhaust systems, cracked exhaust manifolds or damaged or missing gaskets or donuts will cause air leaks.
An air leak forward of the DPF will change the sensor readings resulting in the code
Defective ECU strategies or components will prevent proper regeneration

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed. Now, clear the codes and test-drive the vehicle to see if the code is reset. Look for damage to the tank indicating impact that may have damaged the fuel pump or sender.

Process Tips

Diagnostic trouble code P2813 Morris Cowley is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P2813 Morris Cowley.

Fortunately, P2813 Morris Cowley is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.