P2787 Datsun Z Diagnostic Trouble Code

P2787 Datsun Z code definition:
P2787 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Datsun Z.

P2787 Datsun Z is described as Fuel Rail Pressure Sensor Circuit Malfunction. This code is strictly about the incoming signal from the FRP (fuel rail pressure) sensor falling below the calibrated limit for a certain period of time. The PCM then uses this data to provide the right strategies for the fuel delivery and ignition timing of the engine.

Symptoms

Symptoms of a P2787 Datsun Z diagnostic trouble code may include:

Fuel pressure too low
Rich or lean exhaust
Diminished fuel efficiency
Reduction in engine performance, especially at low RPM levels

Possible Causes :

A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
Some aftermarket accessories and performance modifications
Faulty IMRC actuator/sensor

Common Misdiagnoses

Vehicle Speed Output Circuit Problem
Cruise Control Servo Indicates Low Problem
A/C System High Pressure High Temperature Problem
PCM Stack Overrun Problem
Transmission Control Module Reprogrammable Memory Problem

Repair Processes :

With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Now, clear the codes and test-drive the vehicle to see if the code is reset. Look at the plug wires to make sure they are not burnt or laying on the exhaust.

Process Tips

Diagnostic trouble code P2787 Datsun Z is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P2787 Datsun Z.

Fortunately, P2787 Datsun Z is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.