P273A Hyundai Veloster Diagnostic Trouble Code

P273A Hyundai Veloster code definition:
P273A is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Hyundai Veloster.

P273A Hyundai Veloster is described as Fuel Rail Pressure Sensor Circuit Malfunction. This code is strictly about the incoming signal from the FRP (fuel rail pressure) sensor falling below the calibrated limit for a certain period of time. Other serious codes may cause this code to pop up, and they may come with dangerous drivability issues that may expose you to safety risks and cause damage to the engine in the long run.

Symptoms

Symptoms of a P273A Hyundai Veloster diagnostic trouble code may include:

Misfire
Misfire
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
Reduction in engine performance, especially at low RPM levels

Possible Causes :

Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.
Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.
An air leak forward of the DPF will change the sensor readings resulting in the code

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

Find out what kind of system you have and verify that voltage to the fuel level sensor is present at the fuel pump wiring harness. Look at the plug wires to make sure they are not burnt or laying on the exhaust. Pack the connector cavity with dielectric silicone compound (same stuff they use for light bulb sockets and spark plug wires) and reassemble.

Process Tips

Diagnostic trouble code P273A Hyundai Veloster is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P273A Hyundai Veloster.

Fortunately, P273A Hyundai Veloster is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.