P2728 Knox Model O Diagnostic Trouble Code

P2728 Knox Model O code definition:
P2728 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Knox Model O.

P2728 Knox Model O is described as Fuel System Too Rich, which basically means bank 1's oxygen sensor has detected a rich condition of fuel. This means there's not enough oxygen in the exhaust from too much fuel being delivered into the air and gas mixture for combusion. The spark should have a light tan color. If the sensor probe comes with white and chalky parts, this means it has been lagging between switching phases, and should be replaced.

Symptoms

Symptoms of a P2728 Knox Model O diagnostic trouble code may include:

Faulty PCM
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
Poor acceleration
Hesitation upon acceleration

Possible Causes :

Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.
Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.
A large air leak at or near the number one oxygen sensor would also cause a lean mixture.

Common Misdiagnoses

Exhaust Gas Recirculation System Valve 1 Problem
BBV Sensor Circuit Low Voltage Problem
Transmission Engaged At High Throttle Angle Problem
Cruise Inhibit Control Circuit Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem

Repair Processes :

Look for damage to the tank indicating impact that may have damaged the fuel pump or sender. Look at the plug wires to make sure they are not burnt or laying on the exhaust. Pack the connector cavity with dielectric silicone compound (same stuff they use for light bulb sockets and spark plug wires) and reassemble.

Process Tips

Diagnostic trouble code P2728 Knox Model O is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P2728 Knox Model O.

Fortunately, P2728 Knox Model O is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.