P2714 Mazda Mazda 3 Ii Diagnostic Trouble Code

P2714 Mazda Mazda 3 Ii code definition:
P2714 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Mazda Mazda 3 Ii.

P2714 Mazda Mazda 3 Ii is defined as Cylinder 3 Injector Circuit Malfunction. This code means the PCM (powertrain control module, also known as ECM or engine control) has detected a problem in the injector or its wiring, or in injector circuit for cylinder 3. This is because the barometric pressure sensor is part of the MAF sensor. Sometimes, the MAF's sensing wire can accumulate and get covered with dirt, dust and/or oil residue, which can also lead to the error code.

Symptoms

Symptoms of a P2714 Mazda Mazda 3 Ii diagnostic trouble code may include:
  • Misfire
  • Misfire
  • The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
  • Hesitation upon acceleration
Place of P2714 in engine

Possible Causes :

  • A plugged converter will cause of host of driveability problems as well as set this code. A severely plugged converter will result in the inability to increase rpm when under load. Look for a code such as P0421 -- catalytic converter efficiency below threshold if the converter indicating a faulty converter.
  • Dirty air cleaner element Damaged DPF
  • An air leak forward of the DPF will change the sensor readings resulting in the code

Common Misdiagnoses

  1. Vehicle Speed Output Circuit Problem
  2. Cruise Control Servo Indicates Low Problem
  3. A/C System High Pressure High Temperature Problem
  4. PCM Stack Overrun Problem
  5. Transmission Control Module Reprogrammable Memory Problem

Repair Processes :

Pack the connector cavity with dielectric silicone compound (same stuff they use for light bulb sockets and spark plug wires) and reassemble. Look for damage to the tank indicating impact that may have damaged the fuel pump or sender.

Process Tips

Diagnostic trouble code P2714 Mazda Mazda 3 Ii is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P2714 Mazda Mazda 3 Ii.

Fortunately, P2714 Mazda Mazda 3 Ii is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

Diagnostic Trouble Code look-up and check engine light code viewer.

Copyright 2021 - https://diagnosticTrouble.com

Small Logo