P2457 Audi A2 Diagnostic Trouble Code

P2457 Audi A2 code definition:
P2457 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Audi A2.

P2457 Audi A2 is described as Fuel System Too Rich, which basically means bank 1's oxygen sensor has detected a rich condition of fuel. This means there's not enough oxygen in the exhaust from too much fuel being delivered into the air and gas mixture for combusion. As you drive and when specific conditions are slowly met, the vapors will gradually purge from the charcoal canister and will get burned within your engine.

Symptoms

Symptoms of a P2457 Audi A2 diagnostic trouble code may include:

Misfire
Misfire
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
Reduction in engine performance, especially at low RPM levels

Possible Causes :

Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.
Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.
An air leak forward of the DPF will change the sensor readings resulting in the code

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

Look for damage to the tank indicating impact that may have damaged the fuel pump or sender. Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed. Pack the connector cavity with dielectric silicone compound (same stuff they use for light bulb sockets and spark plug wires) and reassemble.

Process Tips

Diagnostic trouble code P2457 Audi A2 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P2457 Audi A2.

Fortunately, P2457 Audi A2 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.