P2440 Diagnostic Trouble Code


P2440 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code.

It is considered generic because it applies to all makes and models of vehicles, although specific repair steps may be different depending on your car model.

Symptoms

Symptoms of a P2440 diagnostic trouble code may include:
  • Faulty or damaged wiring
  • The engine oil will exhibit dilution from the ECUs attempts to increase engine temperature. Some vehicles advance the fuel injection timing slightly after top center to afterburn a small amount of fuel to increase exhaust temperatures. Some of this fuel enters the crankcase. When the ECU determines the necessity to regenerate the DPF, the service life of the oil be shortened significantly
  • Poor fuel economy
  • Rich or lean exhaust
Place of P2440 in engine

Possible Causes :

  • Faulty IMRC actuator relay (if equipped)
  • A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
  • A large vacuum leak would cause a massive amount of un-metered air to enter the intake manifold resulting in an overly lean mixture.

Repair Processes :

Once located, visually inspect the connectors and wiring. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed.

Process Tips

Diagnostic trouble code P2440 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P2440.

Fortunately, P2440 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.

P1205 Trouble Code For Specific Cars

Diagnostic Trouble Code look-up and check engine light code viewer.

Copyright 2019 - https://diagnosticTrouble.com

Small Logo