P241D Buick Allure Diagnostic Trouble Code

P241D Buick Allure code definition:
P241D is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Buick Allure.

P241D Buick Allure is defined as Cylinder 3 Injector Circuit Malfunction. This code means the PCM (powertrain control module, also known as ECM or engine control) has detected a problem in the injector or its wiring, or in injector circuit for cylinder 3. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a P241D Buick Allure diagnostic trouble code may include:

Engine surge
Blown fuse (if applicable)
Lack of power
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected

Possible Causes :

A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
Faulty IMRC actuator relay (if equipped)
Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)

Common Misdiagnoses

Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
Kick-Down Switch Failed Short Problem
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit Problem

Repair Processes :

You might continue by connecting the scanner to the vehicle diagnostic connector and retrieving all stored codes and freeze frame data. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector.

Process Tips

Diagnostic trouble code P241D Buick Allure is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P241D Buick Allure.

Fortunately, P241D Buick Allure is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.