P238E Chevrolet Impala Diagnostic Trouble Code

P238E Chevrolet Impala code definition:
P238E is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Chevrolet Impala.

P238E Chevrolet Impala is triggered when the bank 1 camshaft position sensor doesn't match the signal from the crankshaft position sensor. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a P238E Chevrolet Impala diagnostic trouble code may include:

Excessive exhaust leak
Hesitation upon acceleration
Malfunction Indicator Lamp (MIL) illuminated
Rich or lean exhaust

Possible Causes :

Faulty IMRC actuator relay (if equipped)
A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.

Common Misdiagnoses

Exhaust Gas Recirculation System Valve 1 Problem
BBV Sensor Circuit Low Voltage Problem
Transmission Engaged At High Throttle Angle Problem
Cruise Inhibit Control Circuit Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem

Repair Processes :

Now, clear the codes and test-drive the vehicle to see if the code is reset. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector.

Process Tips

Diagnostic trouble code P238E Chevrolet Impala is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P238E Chevrolet Impala.

Fortunately, P238E Chevrolet Impala is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.