P237D Volvo 360 Diagnostic Trouble Code

P237D Volvo 360 code definition:
P237D is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Volvo 360.

P237D Volvo 360 is triggered when the bank 1 camshaft position sensor doesn't match the signal from the crankshaft position sensor. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a P237D Volvo 360 diagnostic trouble code may include:

Vacuum leak on the engine
Reduction in engine performance, especially at low RPM levels
Engine surge
Poor acceleration

Possible Causes :

Rusty exhaust systems, cracked exhaust manifolds or damaged or missing gaskets or donuts will cause air leaks.
An air leak forward of the DPF will change the sensor readings resulting in the code
Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)

Common Misdiagnoses

Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
Kick-Down Switch Failed Short Problem
Park/Neutral Postion (PNP) Switch Circuit Engine Torque Signal Circuit Problem

Repair Processes :

If the scan tool has that capability, and the scan tool can operate the IMRC valves, then the problem is either resolved and a simple code clearing is all that's left or a new PCM would be called for. Find out what kind of system you have and verify that voltage to the fuel level sensor is present at the fuel pump wiring harness.

Process Tips

Diagnostic trouble code P237D Volvo 360 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P237D Volvo 360.

Fortunately, P237D Volvo 360 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.