P232A Allard P1 Diagnostic Trouble Code

P232A Allard P1 code definition:
P232A is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Allard P1.

P232A Allard P1 is described as Intake Air Temperature (IAT) Circuit Malfunction. It's actually a general trouble code for a problem on IAT electrical circuit sensor, as it sends incorrect voltage input signals to the PCM. The PCM then uses this data to provide the right strategies for the fuel delivery and ignition timing of the engine.

Symptoms

Symptoms of a P232A Allard P1 diagnostic trouble code may include:

Lack of power
Faulty O2 Sensor
Poor acceleration
Hesitation upon acceleration

Possible Causes :

Some aftermarket accessories and performance modifications
A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
Rough running engine due to misfiring plugs. Many engines have misfire codes to indicate the cylinder effected, such as P0307 for number 7.

Common Misdiagnoses

Vehicle Speed Output Circuit Problem
Cruise Control Servo Indicates Low Problem
A/C System High Pressure High Temperature Problem
PCM Stack Overrun Problem
Transmission Control Module Reprogrammable Memory Problem

Repair Processes :

Oxygen sensors signal the engine management computer the amount of oxygen present in the exhaust, which is used in determining and controlling the fuel ratio. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Once located, visually inspect the connectors and wiring. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors.

Process Tips

Diagnostic trouble code P232A Allard P1 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P232A Allard P1.

Fortunately, P232A Allard P1 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.