P2328 Subaru B11 Diagnostic Trouble Code

P2328 Subaru B11 code definition:
P2328 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Subaru B11.

P2328 Subaru B11 is a DTC or a diagnostic trouble code. It is a check engine light code which indicates that the catalyst's system efficiency is less than the required threshold. In simple terms, it means that more pollution is added into the air than what was supposed to be because of your car. So if the problem persists despite of your diagnosis, then you should never hesitate to take your vehicle to your dealer or to a qualified mechanic.

Symptoms

Symptoms of a P2328 Subaru B11 diagnostic trouble code may include:

The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
Faulty PCM
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
Diminished fuel efficiency

Possible Causes :

An air leak forward of the DPF will change the sensor readings resulting in the code
Rusty exhaust systems, cracked exhaust manifolds or damaged or missing gaskets or donuts will cause air leaks.
Fuel with a large percentage of sulfur will clog the DPF quickly

Common Misdiagnoses

TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem
Problem

Repair Processes :

If the scan tool has that capability, and the scan tool can operate the IMRC valves, then the problem is either resolved and a simple code clearing is all that's left or a new PCM would be called for. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Look at the plug wires to make sure they are not burnt or laying on the exhaust.

Process Tips

Diagnostic trouble code P2328 Subaru B11 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P2328 Subaru B11.

Fortunately, P2328 Subaru B11 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.