P2320 Zender 30-7 Diagnostic Trouble Code

P2320 Zender 30-7 code definition:
P2320 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Zender 30-7.

P2320 Zender 30-7 is described as Oxygen Sensor Circuit No Activity Detected (Bank 1, Sensor 1). This means there's a problem in the front oxygen sensor on Bank 1, as the O2 sensor is inactive. The PCM then uses this data to provide the right strategies for the fuel delivery and ignition timing of the engine.

Symptoms

Symptoms of a P2320 Zender 30-7 diagnostic trouble code may include:

Cherry red hot catalytic converter
Poor acceleration
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
The engine oil will exhibit dilution from the ECUs attempts to increase engine temperature. Some vehicles advance the fuel injection timing slightly after top center to afterburn a small amount of fuel to increase exhaust temperatures. Some of this fuel enters the crankcase. When the ECU determines the necessity to regenerate the DPF, the service life of the oil be shortened significantly

Possible Causes :

Defective ECU strategies or components will prevent proper regeneration
The Mass Airflow sensor is a hot wire that senses the volume of air entering the intake manifold. The computer uses this information to control fuel mixture.
An air leak forward of the DPF will change the sensor readings resulting in the code

Common Misdiagnoses

Vehicle Speed Output Circuit Problem
Cruise Control Servo Indicates Low Problem
A/C System High Pressure High Temperature Problem
PCM Stack Overrun Problem
Transmission Control Module Reprogrammable Memory Problem

Repair Processes :

With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Now, clear the codes and test-drive the vehicle to see if the code is reset.

Process Tips

Diagnostic trouble code P2320 Zender 30-7 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P2320 Zender 30-7.

Fortunately, P2320 Zender 30-7 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.