P2315 Toyota Alphard Diagnostic Trouble Code

P2315 Toyota Alphard code definition:
P2315 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Toyota Alphard.

P2315 Toyota Alphard is triggered when the bank 1 camshaft position sensor doesn't match the signal from the crankshaft position sensor. As you drive and when specific conditions are slowly met, the vapors will gradually purge from the charcoal canister and will get burned within your engine.

Symptoms

Symptoms of a P2315 Toyota Alphard diagnostic trouble code may include:

Faulty O2 Sensor
Lack of power
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
Reduction in engine performance, especially at low RPM levels

Possible Causes :

A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
Some aftermarket accessories and performance modifications
Fuel with a large percentage of sulfur will clog the DPF quickly

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors. Pull the connectors apart and carefully look at the terminals (the metal parts) inside the connectors.

Process Tips

Diagnostic trouble code P2315 Toyota Alphard is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P2315 Toyota Alphard.

Fortunately, P2315 Toyota Alphard is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.