P2311 Trabant 1.1 Diagnostic Trouble Code

P2311 Trabant 1.1 code definition:
P2311 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Trabant 1.1.

P2311 Trabant 1.1 is defined as Knock Sensor Circuit Range Performance (Bank 1 or Single Sensor). This refers to camshaft timing, which in this case is over-retarded. This is because the barometric pressure sensor is part of the MAF sensor. Sometimes, the MAF's sensing wire can accumulate and get covered with dirt, dust and/or oil residue, which can also lead to the error code.

Symptoms

Symptoms of a P2311 Trabant 1.1 diagnostic trouble code may include:

Faulty or damaged wiring
The engine oil will exhibit dilution from the ECUs attempts to increase engine temperature. Some vehicles advance the fuel injection timing slightly after top center to afterburn a small amount of fuel to increase exhaust temperatures. Some of this fuel enters the crankcase. When the ECU determines the necessity to regenerate the DPF, the service life of the oil be shortened significantly
Poor fuel economy
Rich or lean exhaust

Possible Causes :

Faulty IMRC actuator relay (if equipped)
A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
A large vacuum leak would cause a massive amount of un-metered air to enter the intake manifold resulting in an overly lean mixture.

Common Misdiagnoses

TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem
Problem

Repair Processes :

Once located, visually inspect the connectors and wiring. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector.

Process Tips

Diagnostic trouble code P2311 Trabant 1.1 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P2311 Trabant 1.1.

Fortunately, P2311 Trabant 1.1 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.