P2241 Bmw Z3 Diagnostic Trouble Code

P2241 Bmw Z3 code definition:
P2241 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Bmw Z3.

P2241 Bmw Z3 is defined as Ignition Coil B Primary/Secondary Circuit Malfunction.This code is a generic trouble code, meaning it applies to all vehicles equipped with OBD-II tool, or vehicles made since 1996 up to present. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a P2241 Bmw Z3 diagnostic trouble code may include:

If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
Corroded or damaged connector
Reduction in engine performance, especially at low RPM levels
Rich or lean exhaust

Possible Causes :

The Mass Airflow sensor will also cause this problem. Mass Airflow circuit malfunction.
Fuel with a large percentage of sulfur will clog the DPF quickly
Some aftermarket accessories and performance modifications

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

Find out what kind of system you have and verify that voltage to the fuel level sensor is present at the fuel pump wiring harness. Now, clear the codes and test-drive the vehicle to see if the code is reset.

Process Tips

Diagnostic trouble code P2241 Bmw Z3 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P2241 Bmw Z3.

Fortunately, P2241 Bmw Z3 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.