P2142 Frazer Nash Falcon Diagnostic Trouble Code
P2142 Frazer Nash Falcon code definition:
P2142 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Frazer Nash Falcon.
P2142 Frazer Nash Falcon is defined as Knock Sensor Circuit Range Performance (Bank 1 or Single Sensor). This refers to camshaft timing, which in this case is over-retarded. As you drive and when specific conditions are slowly met, the vapors will gradually purge from the charcoal canister and will get burned within your engine.
Symptoms
Symptoms of a P2142 Frazer Nash Falcon diagnostic trouble code may include:
- Poor acceleration
- Cherry red hot catalytic converter
- Possible spark knock (detonation / pre-ignition)
- Reduction in engine performance, especially at low RPM levels
|
Possible Causes :
- A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
- Some aftermarket accessories and performance modifications
- A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
|
Common Misdiagnoses
- Exhaust Gas Recirculation System Valve 1 Problem
- BBV Sensor Circuit Low Voltage Problem
- Transmission Engaged At High Throttle Angle Problem
- Cruise Inhibit Control Circuit Problem
- TFP Valve Position Switch-Drive Without Drive Ratio Problem
Repair Processes :
With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground.
Pack the connector cavity with dielectric silicone compound (same stuff they use for light bulb sockets and spark plug wires) and reassemble.
Look at the plug wires to make sure they are not burnt or laying on the exhaust.
Process Tips
Diagnostic trouble code P2142 Frazer Nash Falcon is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.
Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P2142 Frazer Nash Falcon.
Fortunately, P2142 Frazer Nash Falcon is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.
Diagnostic Trouble Code look-up and check engine light code viewer.
About Us | Contact | Privacy
Copyright 2024 - https://DiagnosticTrouble.com