P20E6 Amphicar 770 Diagnostic Trouble Code

P20E6 Amphicar 770 code definition:
P20E6 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Amphicar 770.

P20E6 Amphicar 770 is defined as Knock Sensor Circuit Range Performance (Bank 1 or Single Sensor). This refers to camshaft timing, which in this case is over-retarded. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a P20E6 Amphicar 770 diagnostic trouble code may include:

Cherry red hot catalytic converter
Poor acceleration
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected

Possible Causes :

A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
Faulty IMRC actuator relay (if equipped)
An air leak forward of the DPF will change the sensor readings resulting in the code

Common Misdiagnoses

Exhaust Gas Recirculation System Valve 1 Problem
BBV Sensor Circuit Low Voltage Problem
Transmission Engaged At High Throttle Angle Problem
Cruise Inhibit Control Circuit Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem

Repair Processes :

It should be pretty close to battery voltage (12 volts). If not, then this is the circuit that has the problem. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Oxygen sensors signal the engine management computer the amount of oxygen present in the exhaust, which is used in determining and controlling the fuel ratio.

Process Tips

Diagnostic trouble code P20E6 Amphicar 770 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P20E6 Amphicar 770.

Fortunately, P20E6 Amphicar 770 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.