P20A7 Austin A40 Diagnostic Trouble Code

P20A7 Austin A40 code definition:
P20A7 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Austin A40.

P20A7 Austin A40 is described as Fuel Rail Pressure Sensor Circuit Malfunction. This code is strictly about the incoming signal from the FRP (fuel rail pressure) sensor falling below the calibrated limit for a certain period of time. Other serious codes may cause this code to pop up, and they may come with dangerous drivability issues that may expose you to safety risks and cause damage to the engine in the long run.

Symptoms

Symptoms of a P20A7 Austin A40 diagnostic trouble code may include:

Faulty O2 Sensor
Lack of power
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.

Possible Causes :

An air leak forward of the DPF will change the sensor readings resulting in the code
Rusty exhaust systems, cracked exhaust manifolds or damaged or missing gaskets or donuts will cause air leaks.
Fuel with a large percentage of sulfur will clog the DPF quickly

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

Once located, visually inspect the connectors and wiring. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector.

Process Tips

Diagnostic trouble code P20A7 Austin A40 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P20A7 Austin A40.

Fortunately, P20A7 Austin A40 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.