P2013 Scania-vabis Limousine Diagnostic Trouble Code

P2013 Scania-vabis Limousine code definition:
P2013 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Scania-vabis Limousine.

P2013 Scania-vabis Limousine is described as Oxygen Sensor Circuit No Activity Detected (Bank 1, Sensor 1). This means there's a problem in the front oxygen sensor on Bank 1, as the O2 sensor is inactive. Other symptoms that may indicate this problem are when the Check Engine Light illuminates and when there is a visible lack of engine power.

Symptoms

Symptoms of a P2013 Scania-vabis Limousine diagnostic trouble code may include:

Engine surge
Blown fuse (if applicable)
Lack of power
Hesitation upon acceleration

Possible Causes :

Some aftermarket accessories and performance modifications
A faulty oxygen sensor. This will set a code in itself, however, a faulty oxygen sensor does not automatically condemn the sensor. The code just means that the sensor signal was not within specifications. An air leak or any of the above will cause an erroneous signal. There is a multitude of O2 codes relating to O2 performance which gives a clue to the problematic area.
Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)

Common Misdiagnoses

TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem
Problem

Repair Processes :

Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors. Pull the connectors apart and carefully look at the terminals (the metal parts) inside the connectors.

Process Tips

Diagnostic trouble code P2013 Scania-vabis Limousine is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P2013 Scania-vabis Limousine.

Fortunately, P2013 Scania-vabis Limousine is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.