P1F0E Daihatsu Sportrak Diagnostic Trouble Code

P1F0E Daihatsu Sportrak code definition:
P1F0E is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Daihatsu Sportrak.

P1F0E Daihatsu Sportrak is described as Fuel System Too Rich, which basically means bank 1's oxygen sensor has detected a rich condition of fuel. This means there's not enough oxygen in the exhaust from too much fuel being delivered into the air and gas mixture for combusion. This is because the barometric pressure sensor is part of the MAF sensor. Sometimes, the MAF's sensing wire can accumulate and get covered with dirt, dust and/or oil residue, which can also lead to the error code.

Symptoms

Symptoms of a P1F0E Daihatsu Sportrak diagnostic trouble code may include:

The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
Faulty PCM
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
Diminished fuel efficiency

Possible Causes :

Faulty IMRC actuator/sensor
A large vacuum leak would cause a massive amount of un-metered air to enter the intake manifold resulting in an overly lean mixture.
An air leak forward of the DPF will change the sensor readings resulting in the code

Common Misdiagnoses

Vehicle Speed Output Circuit Problem
Cruise Control Servo Indicates Low Problem
A/C System High Pressure High Temperature Problem
PCM Stack Overrun Problem
Transmission Control Module Reprogrammable Memory Problem

Repair Processes :

Once located, visually inspect the connectors and wiring. Look for rubbing, scraping, bare wires, worn spots or melted plastic connectors. Find out what kind of system you have and verify that voltage to the fuel level sensor is present at the fuel pump wiring harness.

Process Tips

Diagnostic trouble code P1F0E Daihatsu Sportrak is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P1F0E Daihatsu Sportrak.

Fortunately, P1F0E Daihatsu Sportrak is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.