P1EE8 Mazda Mx-3 Diagnostic Trouble Code

P1EE8 Mazda Mx-3 code definition:
P1EE8 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Mazda Mx-3.

P1EE8 Mazda Mx-3 is defined as Knock Sensor Circuit Range Performance (Bank 1 or Single Sensor). This refers to camshaft timing, which in this case is over-retarded. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a P1EE8 Mazda Mx-3 diagnostic trouble code may include:

Faulty PCM
The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
Poor acceleration
Hesitation upon acceleration

Possible Causes :

Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.
Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.
A large air leak at or near the number one oxygen sensor would also cause a lean mixture.

Common Misdiagnoses

IC Circuit High Voltage Problem
Control Module Throttle Actuator Position Performance Problem
Air Conditioning (A/C) Clutch Feedback Circuit High Voltage Problem
Cruise Vehicle Speed/Set Speed Difference Too High Problem
PCM Stack Overrun Problem

Repair Processes :

Find out what kind of system you have and verify that voltage to the fuel level sensor is present at the fuel pump wiring harness. Check to make sure they are not burnt or corroded. If in doubt, get some Electrical Contact cleaner at any parts store if cleaning of the terminals is needed.

Process Tips

Diagnostic trouble code P1EE8 Mazda Mx-3 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P1EE8 Mazda Mx-3.

Fortunately, P1EE8 Mazda Mx-3 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.