P1EE0 Gmc Yukon Diagnostic Trouble Code

P1EE0 Gmc Yukon code definition:
P1EE0 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Gmc Yukon.

P1EE0 Gmc Yukon is defined as Cylinder 3 Injector Circuit Malfunction. This code means the PCM (powertrain control module, also known as ECM or engine control) has detected a problem in the injector or its wiring, or in injector circuit for cylinder 3. There are two wires dedicated for each coil; one is battery feed which usually comes from the distribution center, and the other one for the coil driver circuit from the PCM. The PCM grounds or ungrounds the circuit to activate or deactivate the coil.

Symptoms

Symptoms of a P1EE0 Gmc Yukon diagnostic trouble code may include:

Diminished fuel efficiency
Fuel pressure too high
Malfunction Indicator Lamp (MIL) illuminated
Misfire

Possible Causes :

Faulty IMRC actuator/sensor
A large vacuum leak would cause a massive amount of un-metered air to enter the intake manifold resulting in an overly lean mixture.
Low fuel pressure caused by a clogged filter, failing fuel pump, failed fuel pressure regulator or clogged or leaking injectors.

Common Misdiagnoses

Exhaust Gas Recirculation System Valve 1 Problem
BBV Sensor Circuit Low Voltage Problem
Transmission Engaged At High Throttle Angle Problem
Cruise Inhibit Control Circuit Problem
TFP Valve Position Switch-Drive Without Drive Ratio Problem

Repair Processes :

If the scan tool has that capability, and the scan tool can operate the IMRC valves, then the problem is either resolved and a simple code clearing is all that's left or a new PCM would be called for. Look at the plug wires to make sure they are not burnt or laying on the exhaust. Find out what kind of system you have and verify that voltage to the fuel level sensor is present at the fuel pump wiring harness.

Process Tips

Diagnostic trouble code P1EE0 Gmc Yukon is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P1EE0 Gmc Yukon.

Fortunately, P1EE0 Gmc Yukon is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.