P1EC5 Nash 400 Diagnostic Trouble Code

P1EC5 Nash 400 code definition:
P1EC5 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Nash 400.

P1EC5 Nash 400 is defined as Cylinder 3 Injector Circuit Malfunction. This code means the PCM (powertrain control module, also known as ECM or engine control) has detected a problem in the injector or its wiring, or in injector circuit for cylinder 3. This is because the barometric pressure sensor is part of the MAF sensor. Sometimes, the MAF's sensing wire can accumulate and get covered with dirt, dust and/or oil residue, which can also lead to the error code.

Symptoms

Symptoms of a P1EC5 Nash 400 diagnostic trouble code may include:

The light may stay on or light intermittently as the DPF regenerates. The engine will be sluggish on acceleration.
Faulty PCM
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected
Diminished fuel efficiency

Possible Causes :

A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
Faulty IMRC actuator relay (if equipped)
An air leak forward of the DPF will change the sensor readings resulting in the code

Common Misdiagnoses

Crankshaft Position Sensor Circuit Performance Problem
TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
Kick-Down Switch Failed Short Problem

Repair Processes :

If the scan tool has that capability, and the scan tool can operate the IMRC valves, then the problem is either resolved and a simple code clearing is all that's left or a new PCM would be called for. With the valve disconnected, the red voltmeter lead should be attached to the IMRC valve power wire and the black voltmeter lead connected to ground. Replace the oxygen sensor that is downstream from the catalytic converter on the side of the engine that does not contain cylinder #1. Also, if a oxygen sensor code stating "heater circuit malfunction" the sensor has most probably failed.

Process Tips

Diagnostic trouble code P1EC5 Nash 400 is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P1EC5 Nash 400.

Fortunately, P1EC5 Nash 400 is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.