P1EA4 Honda Stepwagon Diagnostic Trouble Code

P1EA4 Honda Stepwagon code definition:
P1EA4 is a kind of OBD-II Diagnostic P-Powertrain Diagnostic Trouble Code for Honda Stepwagon.

P1EA4 Honda Stepwagon is described as Fuel System Too Rich, which basically means bank 1's oxygen sensor has detected a rich condition of fuel. This means there's not enough oxygen in the exhaust from too much fuel being delivered into the air and gas mixture for combusion. If the car doesn't start, they will proceed by testing the voltage at the fuel pump connector and see if the fuel pump relay, fuse, and PCM circuitry should be inspected.

Symptoms

Symptoms of a P1EA4 Honda Stepwagon diagnostic trouble code may include:

Engine surge
Blown fuse (if applicable)
Lack of power
If the DPF is not cleared the ECU will revert to the "Limp Home Mode" until the situation is corrected

Possible Causes :

A large air leak at or near the number one oxygen sensor would also cause a lean mixture.
Faulty IMRC actuator relay (if equipped)
Rarely - faulty Powertrain Control Module (PCM-programming required after replacement)

Common Misdiagnoses

Crankshaft Position Sensor Circuit Performance Problem
TP Sensor Learn Not Complete Problem
Low Coolant Circuit Problem
Cruise Control System - Vehicle Accel Too High Problem
Kick-Down Switch Failed Short Problem

Repair Processes :

You might continue by connecting the scanner to the vehicle diagnostic connector and retrieving all stored codes and freeze frame data. Look for missing ground strap or a rusty ground where the fuel tank is grounded to the frame. Check for damage to the wiring harness connector. Look at the plug wires to make sure they are not burnt or laying on the exhaust.

Process Tips

Diagnostic trouble code P1EA4 Honda Stepwagon is not difficult to diagnose and repair. Thus, it always pays to have a qualified technician to look after your vehicle should this error code arise.

Diagnosing this code requires the engine to be in good running shape, without unmetered air entering the engine. If other codes that relates to misfiring condition, lean running or air entering the engine is present, then you must first fix those error codes before P1EA4 Honda Stepwagon.

Fortunately, P1EA4 Honda Stepwagon is a fairly common OBD code, meaning that it applies to all makes and models of vehicles made after 1996.